Chaning axies for Fusion 360

[Aliaz]

Hey!

So I just switched from Solidworks to Fusion 360 (new job). And I have a SpaceMouse Pro 3D. It worked great in Solidworks but i cant make it work in fusion. The problem is I can not switch axies. So I want the zoom control to be up and down. I checek this forum and i found some solutions, but non of them really worked, or I couldn't make it work :/

Where do I find these config files, where I can change the axies?


Kind regards,
Aljaž

[UtaSH]

Hi Aljaž,

in the driver panel, the 3Dconnexion properties there is a button for the "Advanced Settings". Open this for Fusion and then change the Zoom direction to "Up/Down". This should do the trick.