Spaceball4000FLX Serial and spaceNavigator on same computer

Questions and answers about 3Dconnexion devices on Windows.

Moderator: Moderators

Post Reply
vogtbran
Posts: 1
Joined: Wed Apr 04, 2007 9:42 am

Spaceball4000FLX Serial and spaceNavigator on same computer

Post by vogtbran » Wed Apr 04, 2007 9:58 am

I am currently using a SpaceBall - serial port connection at work and I just bought a SpaceNavigator. I installed the new software and the SpaceNavigator worked but my SpaceBall did not. I uninstalled the new software and installed the old v2-8-2 software and my SpaceBall is working again. What will happen when I plug my SpaceNavigator into my computer? Can I switch back and forth between these 2 products?

FYI - I am not trying to run these products at the same time.

jwick
Moderator
Moderator
Posts: 2642
Joined: Wed Dec 20, 2006 2:25 pm
Location: USA
Contact:

Post by jwick » Wed Apr 04, 2007 10:12 am

Hi vogtbran,

Unfortunately you perfectly timed the crossroads between device support. 2.8.2 was done before the SpaceNavigator was anything more than a dream, so it doesn't support the SN.

OTOH, 3.x which does support the SN, doesn't support serial devices.

The only solution is to do the uninstall/install procedure that you are doing.

Jim
3Dx Software Development

Post Reply