Installation Process

If you have questions or comments concerning any non-support related 3Dconnexion topic, please use this forum.

Moderator: Moderators

Post Reply
garyacrowellsr
Posts: 1
Joined: Mon May 18, 2020 6:30 pm

Installation Process

Post by garyacrowellsr » Mon May 18, 2020 6:38 pm

New Spacemouse Compact.

Following the quickstart guide:
  • Plug the USB into the back of the PC.
    Install the drivers from the link.
    Fill out the registration form page.
    Fill in the product serial number.
    Where is the product serial number?
    Oh, on the label attached to the USB connector.
    Unplug the USB from the back of the PC, moving the PC to plug/unplug.
    Try to read the microscopic serial number on the label.
    Go find a magnifying glass.
    Read and enter the serial number.
    Move the PC and plug the USB back in.
Not a well-thought-out process.

Post Reply