I'm using the spacemouse pro with blender and 3DCoat, when a new version of 3d coat is installed and launched, it's usual for the 3dconnexion preferences to reset to default. last time it happened I just restored, it did not work but I kept clicking in 3dcoat for a few minutes and the preferences suddenly re-appeared
(I have lots of radial menus setup, I don't think I could redo them easily by hand as it's a whole lot of shortcuts, that's why I save regularly my preferences files)
Except today when it suddently/randomly restored my prefs while clicking for a few minutes inside 3dcoat, it did not restore the blender ones (because I imported just the 3dCoat ones) so I re-imported my prefs and buttons config, erasing all, but it reset everything to default and it just does not want to make my pref magically re-appear again after a while, the stra,gest thing is I can't even change the default prefs ! if I try to change buttons, it just doe snot want, the default button will replace the one I put as soon as I put it...
anyway I lost a workday and I'm still in deep trouble without these preferences imported again as they should.
TL;DR: pref are all default, they don't want to be edited, importing good ones does nothing.
Thanks for any help !
Prefs reset to default, restoration does nothing D:>
Moderator: Moderators
Re: Prefs reset to default, restoration does nothing D:>
It actually only took me an hour to re-enter all my prefs by hand as the radial menus were still there.
But why does restoring preferences does nothing, dos it even save anything in all these preferences files I save ? their size seems to say yes but restoring the button prefs does not change anything.
Thanks
But why does restoring preferences does nothing, dos it even save anything in all these preferences files I save ? their size seems to say yes but restoring the button prefs does not change anything.
Thanks