Testing Solidworks 2018 SP0.1 and immediately found a problem.
The Spacemouse pro's movements in part mode are very jerky. In assembly mode the moments are smooth as silk.
Pan and rotating with the ordinary mouse is smooth in part mode.
Restarted the computer and Reinstalled 3DxWare 10.5.3 but still same problem.
Uninstalled 2018, Restarted the computer, installed 2017 and movements were again smooth as silk.
Uninstalled 2017, Restarted the computer, installed 2018 and movements were again very jerky in part mode....
Tried even the older 3DxWare 10.4.9 but it did not help
Only me who has this problem?
Any suggestions??
Solidworks 2018 SP0.1 - Movements in part mode very jerky
Moderator: Moderators
Re: Solidworks 2018 SP0.1 - Movements in part mode very jerky
THIS is REALLY odd.
Creating a new part from a 2018 default part templet, it moves around smoothly.
Now to the oddly
Opening/switch to my old part after creating the part above, my old part will also move around smoothly.
Saving all and close SW and reopen my old part and the "2018 default templet part" and both has a jerky movements again till i crate a new "2018 default templet part"
Creating a part from my old part templets does not give the same result....
Again, move, pan rotate with the mouse is always smooth.
Creating a new part from a 2018 default part templet, it moves around smoothly.
Now to the oddly
Opening/switch to my old part after creating the part above, my old part will also move around smoothly.
Saving all and close SW and reopen my old part and the "2018 default templet part" and both has a jerky movements again till i crate a new "2018 default templet part"
Creating a part from my old part templets does not give the same result....
Again, move, pan rotate with the mouse is always smooth.