Solid Edge v19 - Uneven navigation speed in camera mode

Falzhobel · Post by **Falzhobel** » Thu Dec 06, 2007 5:47 pm

In solid edge v19, I set my space navigator to "camera mode" in the "plugin" menu of solid edge (perspective mode enabled previously).

I can pan, tilt and rotate just fine, but when I combine two movements, the speed is reduced greatly and it takes forever to rotate around my part while keeping it centered.

I have tried every possible combination of sensitivity in the 3dxWare software, but its the combination of movements that slows the speed.

I want the same smoothness as in google sketchup (in camera mode too) but I can't seem to get it.

What can I do?

Thx

Peter · Post by **Peter** » Mon Dec 10, 2007 9:30 am

Falzhobel,
Perhaps you can tell me what version of the 3dx driver you have installed at this time?
Also, has this problem just begun to happen or has it been ongoing?
Also, can you tell me how much memory is on your graphics card? Thanks, the extra info will help us resolve the problem that you are having.

Peter

Falzhobel · Post by **Falzhobel** » Mon Dec 10, 2007 9:41 am

Peter,

The versions are :
Release Version: 3.4.2
(Driver Version: 6.4.4)
Firmware Version: 3.18
Device Type: SpaceNavigator

It's always been like that.

And as for the memory, I have a 8800GTS 640 MB, and a top notch PC ;P

Thx
Falzhobel