Mastercam rotational center
Moderator: Moderators
-
- Posts: 1
- Joined: Fri Jun 01, 2007 11:08 am
Mastercam rotational center
When using "pick rotational center",It does not use the selected point for "roll". Is there a setting I'm missing? In addition it would be nice to use this selected point to be a selected point for zoom.
Hi specprogrammer,
The support for 3D Mice in Mastercam was developed by the application editors, not 3Dconnexion. In these cases, we suggest customers to send the request to application editor Customer Editor. We appreciate if you could post here the information you may receive from them for the benefit of other Mastercam users.
The support for 3D Mice in Mastercam was developed by the application editors, not 3Dconnexion. In these cases, we suggest customers to send the request to application editor Customer Editor. We appreciate if you could post here the information you may receive from them for the benefit of other Mastercam users.
Nuno Gomes