Driver 10.6.3 issue in SketchUp 2019

Questions and answers about 3Dconnexion devices on macOS.

Moderator: Moderators

Post Reply
slbaumgartner
Posts: 32
Joined: Wed May 31, 2017 2:15 pm

Driver 10.6.3 issue in SketchUp 2019

Post by slbaumgartner »

I installed the 10.6.3 driver after it came out in July (on macOS 10.4.6, mid-2012 15" MBP Retina, SketchUp 2019.2). Since then after a modest period of use (a minute maybe) the model enters into endless spin and zoom out, eventually disappearing. If I close or save the model after this starts happening , SketchUp crashes hard. I uninstalled 10.6.3 and reinstalled 10.6.1, and the problem went away, so I conclude that 10.6.3 is bugged.

Has anyone else seen anything similar? Is there any workaround other than backing out to the prior driver? Is anyone at 3DConnexion aware of this problem?
Post Reply