3Dconnexion Forum

I found the measure command, it was under quick snaps. As i remember it was under tools before, but i might be wrong

i'm not running 2009, but after the update i can't map the measure command, it's under the toolsmenu

That didn't help, but i found out what caused the problem, I tried out Windowblinds and this software caused the problem.

a workaround is to start the 3dconnexion driver first and then load windowblinds, but i think i will remove the software instead.

Anyway thanks for your help.

Here we might have something,
When i open the 3Dconnexion Control Panel , the drop down menu shows "Internal Error" and if i try to switch to Any Application i get a error message and the driver close.

If i then start the driver again with Solidworks running it working as it should.

Deleting the saved profiles doesn't help.

I'm using a Spacepilot and somehow the application i'm using doesn't show up on the spacepilots display. For example in solidworks, it just says Any Application. But i can configure the buttons and they work as they should. the same happens i google earth, the display shows Any Application. I have r...