kenrinc wrote:It works fine with a blank document. But my entire folder of SketchUp docs that I've created over the past year cannot be used with the SN. It doesn't not work. I get the 1hz or slower jerky motion. When I use the mouse, no problem at all. Spin around and orbit like it's a pro workstation. I know it's a Mac drive problem because it works fine on my Windows box using the same documents. Simplifying the drawing doesn't help.
I know about the preferences but the axis are not configurable. They are able to be turned on or off and reversed but you cannot map roll (turn SE left right) to be something else, for instance. They are fixed.
kenrinc wrote:Looking at this again today it is deffinetly the documents that I'm using but all the documents are clean. They have been purged of all extraneous data and in some cases if certain items that are complex are removed it does speed up the use of SN but not enough to make it usable.
Besides, I can twirl this thing upside down and backward in the blink of an eye using the mouse!!
kenrinc wrote:Leopard 10.5.2
It works fine in a blank document any other document I have it doesn't work.
jeremy wrote:Thanks for your reply.
Yes, I tried that and Sketchup now works - sort off. It works very smoothly for about 30 seconds then gets 'jumpy' or jerky for the rest of the session. at the rate of about two thirds of a second. This is in any movement. smooth then stop smooth stop and so on. This jumpy behavior will last indefinitely, however if I change directions like up-down-up-down five or six times quickly it seems to reset it so it is again smooth. The smoothness of control lasts about 30 seconds, and than the jerkiness starts up again. This behavior is consistent with all versions of Sketchup I have. Open app's, or lack thereof have no effect.
I have tried fiddiling with stuff like I did for vectorworks, but I can't seem to get it stop 'jerking'
So... there is still some kind of issue going on....
Google Earth, and vectorworks do not have this issue. They are all smooth as silk. I have 2GB of memory and dual 2.66 intel (mac).
So thanks for sort of solving that issue. If you have any ideas I would appreciate it.
*****Any luck finding the 'picture viewer'?*****
Users browsing this forum: No registered users and 1 guest