jclark wrote:I can't get this to work at all.
Even in Pro/E, sure the device works....but it's not centering so I get a slow bleed spin going on. Very annoying.
Pro/Toolkit application "3DxProENGINEER" was built to run on a newer version of Pro/ENGINEER.
Pro/Toolkit version 0.0, Pro/ENGINEER version 27.0
Brieldo wrote:I too am having this problem. I followed the steps to configure the config file for the SpacePilot within the Pro/E directory, but I get an error saying the following:
"Pro/TOOLKIT registry file C:\Program Files\proeWildfire 3.0\text\protk.dat cannot spawn application 3DxProENGINEER; read error 'No such file or directory'
Any thoughts on this?
Users browsing this forum: No registered users and 5 guests