I have been unable to get my Spacenavigator to recognize when I plug it in to my system.
I am Running windows 7 64-bit, 8GB Ram, i5, and SSD drive. However my Spacenavigator lights up when I plug it into my mac, so I dont think its a hardware issue. I have tried to uninstall My generic USB ports but that seemed to do nothing. I am also running the newest driver from the website.
gkleijer wrote:Done the 2 button trick, is has worked but nowadays not anymore.
Probably also need a firmware update for the device.
Moderators can you help me out?
Barbara wrote:Hello gnax -
The issue corrected by the firmware update is one that happens on Win7 PCs.
With XP there are a couple of other steps to take. You will need to do a clean install of the 3Dconnexion software since the problem could be with a registry key.
Your Space Navigator should be recognized in Device Manager in the Human Interface Devices category as shown here. You can remove it from Device Manager and let Windows recognize it again.
Since the Space Navigator works on another PC , the clean install should correct the problem.
Users browsing this forum: No registered users and 0 guests